I grabbed this mod during the Black Friday sales. And I chose to rate it average because that is how I am feeling about the device. It does work as intended except Geekvape shipped it out with the standard pin installed so I had to swap the pins for the squonk pin. I found that odd seeing how it is a squonk kit.
The Rda is simple but decent. I tried it and then switched to The Drop because it is a better rda imo, but the one provided if it was my only option it does work and provides good enough flavor that it could be used without immediate replacement.
The mod itself has two crucial flaws for my experience. The first being the proprietary bottle and the suction tube. The bottle is rather firm compared to a silicone bottle and the metal feed tube is just in general a bad design for a squonking device. If a soft silicone bottle would of been used with standard tubing then this device would be greatly improved. But in order to use that system they would need to make the second change. They should of cut out a bottle door on the back of the mod that is held on by 4 magnets. As the mod stands now to remove the bottle you have to squeeze the bottle and slide it off the metal tube. When you do this since the bottle and batts share the same door then your batts fall out, and you have to turn the mod back on. Of course you can use a refill bottle to avoid this issue, but a separate back panel door and silicone bottle would greatly improve this device.
As I said the mod does work and I have put one of the new Hcigar softer Vt Inbox bottles on the device, but I had to stretch out the hole a little to have the tube cap fit completely into the top of the bottle. The new style softer Inbox bottle does improve the mod some, but Geekvape could of done a little bit more research to understand what the squonking consumer prefer and what they dislike. But in the end it is a dual battery mass produced squonk that works but as a consumer I feel Geekvape should make a V2 with the suggested improvements, Also as a consumer when considering this device one should understand its short comings and enjoy it for what it does offer which is dual batts and higher powered regulated squonking. Of course it is also bulky but that is to be expected as it is essentially a three batt mod but the bottle takes the space of the third batt. It is a bit bigger than a RX though.
In the current market this mod offers what only a couple main stream mods offer so enjoy it for what it is, or do some modifying to the mod to get it how you want it to perform on a higher level than stock. The chip functions well in power mode from my experience and I have no complaints on that front but I do feel let down by the design choices. .