Geek Bar MATE 60K Disposable Pod 5%

Geek Bar MATE 60K Disposable Pod 5%

The Geek Bar MATE 60K Pod is the pre-filled replacement pod for the MATE 60K system, holding 15mL of 5% (50mg) salt nicotine behind a 1.1ohm dual mesh coil rated for up to 60,000 puffs in Regular Mode and around 30,000 in Pulse. Swapping pods takes seconds through the magnetic connection, and the transparent PCTG body lets you see exactly how much liquid is left instead of guessing. Geek Bar's VPU chip manages heat and wicking in real time, which is what keeps the flavor steady deep into the tank rather than fading once the level drops. An adjustable airflow slider on the base tightens or opens the draw, and a built-in 200mAh battery lets the pod fire on its own for short stretches when the main battery is charging. The pod is also cross-compatible with the Foger Switch Pro, so anyone already running that hardware can use these without buying a second base. This listing is for the pod only - the battery base is sold separately and is required for full performance and recharging.

Browse more Geek Bar disposable vapes or shop our 5% nicotine disposables at MyVpro.

WARNING: This product contains nicotine. Nicotine is an addictive chemical. For adults 21+ only.

Key Features

• Pod Only - battery base sold separately
• 15mL Pre-Filled - sealed at the factory, no refilling or rewicking
• 5% (50mg) Salt Nicotine - the only strength offered for this system
• 1.1ohm Dual Mesh Coil - even heating for consistent flavor and vapor
• Up to 60,000 Puffs - Regular Mode, roughly 30,000 in Pulse Mode
• Built-In 200mAh Battery - limited standalone use without the base
• Transparent PCTG Body - check the liquid level at a glance
• Magnetic Connection - swap flavors in seconds
• Adjustable Airflow - slider control on the pod base
• VPU Chip Technology - real-time heat and wicking management
• Dual Compatibility - fits the MATE 60K base and the Foger Switch Pro

Specification Table

What's Included

• 1 x Geek Bar MATE 60K Replacement Pod

Available Flavors

Amazon Lemonade · Blue Razz Ice · Blue Straws · Blueberry Yummy · Cool Mint · Juicy Peach · Miami Mint · Peach Mango Watermelon · Sky Blue Ice · Sour Apple Ice · Strawberry Banana · Strawberry Kiwi · Strawberry Mint Candy · Triple Berry · Watermelon Ice · White Gummy · White Peach Raspberry

FAQ

Q: Does this come with the battery?
A: No. This listing is for the pod only. You need a compatible battery base, sold separately, to charge the pod and get full performance from it.

Q: Which devices does this pod fit?
A: The Geek Bar MATE 60K battery base and the Foger Switch Pro. If you already own a Switch Pro, these pods will run on your existing hardware.

Q: Can the pod work on its own?
A: For short stretches, yes. The built-in 200mAh battery allows limited standalone use, which is useful while the main base is charging. It is not designed to run the full 60,000 puffs without a base.

Q: How many puffs does one pod last?
A: Up to 60,000 in Regular Mode. Pulse Mode raises the output for denser vapor and drops the figure to roughly 30,000. Real-world results depend on draw length and how often you use Pulse.

Q: Can I refill the pod?
A: No. The pod is a sealed, closed system filled at the factory with 15mL of e-liquid and a pre-installed coil. When it runs empty, replace it with a fresh pod.

Q: How do I know when to replace it?
A: The transparent body shows the liquid level. Once it drops below the coil window, flavor degrades and you may start getting a burnt taste - that is the signal to swap in a new pod.

Q: What nicotine strength is available?
A: 5%, equivalent to 50mg salt nicotine. There is no lower-strength version of this pod.

Frequently Asked Questions

• Q: How do I install the pod onto the Mate 60K dock?
  A: Align the pod with the dock and press down until the magnets click — no twisting or force needed. The Dynamic Galaxy UI will refresh to show the pod's e-liquid level, confirming it's detected. If the screen doesn't update, pull the pod off, wipe the gold contact pins on both pieces with a dry cloth, and reseat it.
• Q: Do I need to prime a new Mate 60K pod before using it?
  A: A quick prime helps: take 2–3 slow, gentle draws to let the wick fully saturate, especially on a brand-new pod. Then vape normally. This is particularly worth doing before switching to Pulse Mode, which demands more from the coil.
• Q: My pod is leaking slightly — is that normal?
  A: A tiny amount of condensation around the mouthpiece or contacts is normal. Steady leaking is not — store the pod upright (mouthpiece up) and keep it out of heat, which thins the e-liquid and forces it past the seals. Wipe the contacts dry before reseating. If a pod keeps leaking after that, its seal has failed and it should be replaced.
• Q: The pod still shows e-liquid but tastes burnt. Why?
  A: Two likely causes: (1) the wick can't keep up — common in Pulse Mode or when chain vaping; rest the device 30–60 seconds between sessions and the flavor usually recovers; (2) the coil is at end of life — toward the very end of a pod, flavor drops off even with liquid still visible on the gauge. If resting doesn't fix it, the pod is done.