GeekVape H45 Aegis Hero 2 Replacement Pods 5mL
Compatible with
Geekvape H45 Aegis Hero 2 Replacement Pods 5mL
Geekvape H45 Mesh Pods are the ready-to-vape version of the Aegis Hero 2 cartridge, sold in 2-packs with the mesh coil already built in. There is nothing to install - fill it, prime it, and go. Each pod holds 5mL, a full millilitre more than the empty 4mL version, and comes in 0.4ohm for a warmer restricted direct-lung draw at 25-35W or 0.6ohm for a tighter MTL pull at 15-25W. Refilling goes through a silicone-stoppered fill port, and a top airflow control ring lets you tighten or open the draw independently of the resistance you chose. The magnetic connection seats the pod instantly, and the pod takes a standard 510 drip tip if you want to swap it. When the coil wears out you replace the whole pod rather than a separate coil - simpler and faster than the 4mL version, at the cost of slightly higher running expense over time.
WARNING: This product is intended for use with nicotine-containing e-liquid. Nicotine is an addictive chemical. For adults 21+ only.
Key Features
- 2-Pack - two pods per pack, coil pre-installed
- Coil Included - no separate coil purchase needed
- 5mL Capacity - larger than the 4mL empty pod version
- Two Resistance Options - 0.4ohm RDTL and 0.6ohm MTL
- Integrated Mesh Coil - even heating for consistent flavor
- Top Airflow Control Ring - adjust the draw independently of resistance
- Silicone-Stoppered Fill Port - mess-free refills
- Magnetic Connection - snaps in and out in seconds
- 510 Drip Tip - swap in your own if you prefer
Specification Table
| Brand | Geekvape |
|---|---|
| Product | H45 (Aegis Hero 2) Mesh Replacement Pods |
| Pack Count | 2 Pods Per Pack |
| Pod Capacity | 5mL |
| Coil Resistance | 0.4ohm (25-35W) / 0.6ohm (15-25W) |
| Coil Type | Integrated Mesh (Non-Replaceable) |
| Coils Included | Yes (Pre-Installed) |
| Vaping Style | 0.4ohm for RDTL, 0.6ohm for MTL |
| Fill System | Silicone Stoppered Fill Port |
| Airflow | Adjustable Top Airflow Control Ring |
| Connection | Magnetic |
| Drip Tip | 510 |
| Compatibility | Geekvape H45 (Aegis Hero 2) Pod Mod Kit |
| Refillable | Yes |
| Ships Filled | No (Empty Pods) |
What's Included
- 2 x Geekvape H45 (Aegis Hero 2) Mesh Replacement Pods
Choosing Your Resistance
- 0.4ohm (25-35W) - warmer, more open restricted direct-lung draw with fuller vapor. Best with higher-VG freebase at 3mg or 6mg
- 0.6ohm (15-25W) - tighter MTL pull, cooler and easier on battery life. Works with 50/50 blends and moderate-strength nic salts
FAQ
Q: Do these pods come with a coil?
A: Yes. The mesh coil is built into the pod, so these are ready to fill and vape. This is the key difference from the 4mL empty pod version, which ships with no coil and requires separate B Series coils.
Q: What is the difference between the 4mL and 5mL pods?
A: The 4mL pod is empty and takes replaceable B Series coils, so you swap coils and keep the pod. The 5mL pod has the coil built in and holds more liquid, so you swap the whole pod when the coil wears out. Both fit the same device.
Q: Which device do these fit?
A: The Geekvape H45, also sold as the Aegis Hero 2. They do not fit the Aegis Hero 5, which uses a newer 6.5mL cartridge.
Q: Can I replace just the coil?
A: No. On the 5mL version the coil is integrated. If you want a replaceable-coil setup, choose the 4mL empty pod and buy B Series coils separately.
Q: Do the pods come filled with e-liquid?
A: No. They ship empty and are refillable. Fill through the silicone-stoppered port with the e-liquid or nic salt of your choice.
Q: Do I need to prime a new pod?
A: Yes. Fill it and let it sit five minutes before the first vape so the cotton saturates fully. Skipping this is the most common cause of a burnt taste on a fresh pod.
Q: How often should I replace a pod?
A: Typically one to two weeks depending on usage and e-liquid. Replace it when flavor turns muted or takes on a burnt edge. Sweetened and dark e-liquids shorten coil life considerably.
